The Generator type exposes the following members.
Back to Top
Methods
Name | Description | |
---|---|---|
Connect(Bus) |
Connects this PowerConversionElement to a Bus.
This is the connection method for three-phase balanced networks. Use
ConnectWye Overload and Connect(Int32, Bus, Int32)
for arbitrarily-phased networks.
(Inherited from PowerConversionElement.) | |
Connect(Int32, NetworkElement, Int32) |
Connects this NetworkElement to a single other NetworkElement, with a specified phasing.
(Inherited from NetworkElement.) | |
Connect(Int32, Bus, Int32) |
Connects a phase of a power conversion element between two phases of a single Bus.
(Inherited from PowerConversionElement.) | |
ConnectBetween(Int32, NetworkElement, Int32, NetworkElement, Int32) |
Connects the NetworkElement between two other NetworkElements, with a specific phasing.
(Inherited from NetworkElement.) | |
ConnectionExists(Int32, NetworkElement, Int32) |
Test if a specific connection between this element and another element on specific phases exists.
(Inherited from NetworkElement.) | |
ConnectWye(Bus, Int32 ) |
Connects this power conversion element in Wye to connectTo. Each phase of
the PowerConversionElement specified in phases will be connected
to the corresponding active phase.
(Inherited from PowerConversionElement.) | |
ConnectWye(Bus, IEnumerable Int32 , IEnumerable Int32 ) |
Connects this power conversion element in Wye to connectTo. Each phase of the
PowerConversionElementin pcElementPhases is connected to the phase of the same index in
busPhases.
(Inherited from PowerConversionElement.) | |
Disconnect(NetworkElement) |
Disconnect this network element from another network element across all phases.
(Inherited from NetworkElement.) | |
OnDeserialization |
Reconstructs the NetworkElement after deserialisation.
(Inherited from NetworkElement.) |
See Also